Differences

This shows you the differences between two versions of the page.

--- synch_tool [2010/11/16 06:19] – created 127.0.0.1
+++ synch_tool [2020/10/19 11:50] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-    * Edit post
-    * Delete post
+===== Home made 2 Bottle type carb sync tool =====
-    * Report this post
-    * Warn user
-    * Information
-    * Reply with quote
-    *
-Home made carb sync tool
+Postby **Shredex »**
+ Sat Feb 28, 2009
-Postby shredex » Sat Feb 28, 2009 5:13 am
 If you are thinking about building a carb sync tool, then I would recommend using the 2-bottle method.
-I just used it and it works wonders! SUPER fine tuning...
+I just used it and it works wonders! SUPER fine tuning...My bike revs so smooth now. it sounds so beautiful.Iv tried the stick and tubing method, all [[http://www.pokerenfrancais.eu/telechargement-poker/|telecharger poker]] I can say is, it sucks and you can risk sucking liquid into your motor.
-My bike revs so smooth now. it sounds so beautiful.
-Iv tried the stick and tubing method, all I can say is, it sucks and you can risk sucking liquid into your motor.
+==== Material List ====
+off GLASS bottles (I used two 9.5oz Starbucks Frappuccino bottles) NOT plastic bottles
+Ft of 3/8"-1/4" clear pvc tubing (the outside is 3/8", and the inside is 1/4")
+off 3/8" sharp metal drill bit
+off rubber stoppers OR rubber chair leg plugs/bumpers (I used 1.5" chair leg plugs)
+off 6mm mig welder tips (there is ten in a pack)
+=== optional ===
+off "Y" connectors that fit the 1/4" tubing.
+off 1/4" rubber caps
+# Zip-ties as required
+=== Pictures ===
+{{:synch-1.jpg|}}
+{{:synch-2.jpg|}}
+{{:synch-3.jpg|}}
+{{:synch-4.jpg|}}
+{{:synch-5.jpg|}}
+{{:synch-6.jpg|}}
+Thanks to CAD600 for his photo's of how he did it
+This one below is Sweekster finish tool
+{{:synch-shredex.jpg|}}
+**//__Thanks to both Sweekster for his Photo & write up & CAD600  for his detailed photo set__//**
+Edited by **Y_G**
-Things you will need:
-GLASS bottles (I used two 9.5oz Starbucks Frappuccino bottles)
-' of 3/8"-1/4" clear pvc tubing (the outside is 3/8", and the inside is 1/4")
-3/8" drill bit
-rubber stoppers OR rubber chair leg plugs/bumpers (I used 1.5" chair leg plugs)
-6mm mig welder tips (there is ten in a pack)
-optional
-"Y" connectors that fit the 1/4" tubing.
-1/4" rubber caps
-# Zip-ties