Differences

This shows you the differences between two versions of the page.

--- led_instrument_warning_lamp_conversion [2010/05/14 05:44] – 127.0.0.1
+++ led_instrument_warning_lamp_conversion [2020/10/19 11:51] (current) – external edit 127.0.0.1
@@ Line 73: / Line 73: @@
 High-beam, Yellow Positive, Black Negative
-Turn/Blinker dark/Green Positive, dark/Brown Positive (light/Green some US models)
+Turn/Blinker, dark/Green Positive, dark/Brown Positive (light/Green some US models)
-Neutral, Brown Positive, light/Blue Negative
+Neutral Brown Positive, light/Blue Negative
 Oil, Brown Positive, Black/Red Negative
@@ Line 89: / Line 89: @@
 {{:turncloseup.jpg|}}
-The holder cut off, i left around 1 inch of wire on the holder, the small piece of wire top left i cut that amount from both wires loom/harness side, so the wires tuck back in tidily don't want them to long
+The holder cut off, i left around 1 inch of wire on the holder, the small piece of wire top right i cut that amount from both wires loom/harness side, so the wires tuck back in tidily don't want them to long
 {{:turncut.jpg|}}
@@ Line 125: / Line 125: @@
 Oil, Brown Positive, Black/Red Negative
+{{:lampsreardone.jpg|}}
+The led's working
-{{:lampsreardone.jpg|}}
+{{:neutturnhbillum.jpg|}}
+{{:oilneutturnillum.jpg|}}
+Inside the speedo lamp covers removed, you may need to do this depending on how bright your led's are (i had to) 10mm led top, 5 mm led bottom, the extra 10m led i added side
+{{:speedoleds.jpg|}}
+Close up of the extra led, i soldered it to the top led legs, fixed it to the speedo body with double sided foam sticky tape
+{{:speedoleds1.jpg|}}