.
Moderators: Site Director, FZR Forum Moderators
- Brutal Tooth
- 50+ Posts

- Posts: 67
- Joined: Mon Mar 01, 2010 5:55 pm
- Location: Cedar Park, Tx
- ragedigital
- 4000+ Posts

- Posts: 4153
- Joined: Wed May 07, 2008 9:30 am
- Location: Northwest St. Louis
Re: 89' 14t/50t conversion? Who has done this?
I ran a 14/49 combination. What are you looking to accomplish?
Thanks for joining and participating in the most "active" FZR Community on the internet!
- Brutal Tooth
- 50+ Posts

- Posts: 67
- Joined: Mon Mar 01, 2010 5:55 pm
- Location: Cedar Park, Tx
Re: 89' 14t/50t conversion? Who has done this?
.
Last edited by Brutal Tooth on Thu Mar 11, 2010 3:44 pm, edited 1 time in total.
- Brutal Tooth
- 50+ Posts

- Posts: 67
- Joined: Mon Mar 01, 2010 5:55 pm
- Location: Cedar Park, Tx
- ragedigital
- 4000+ Posts

- Posts: 4153
- Joined: Wed May 07, 2008 9:30 am
- Location: Northwest St. Louis
Re: 89' 14t/50t conversion? Who has done this?
Depending on your weight, that should get the wheel off the ground. If you want more control, like the majority of stunters, then you want a larger rear sprocket - maybe a 54t or larger and a 13t front sprocket. Course, your mileage will suck and your top speed will suffer, but you'll take off like a "bat outta hell!"
I ran the 14/49 to pull out of the corners harder at Track Days.
I ran the 14/49 to pull out of the corners harder at Track Days.
Thanks for joining and participating in the most "active" FZR Community on the internet!
- Brutal Tooth
- 50+ Posts

- Posts: 67
- Joined: Mon Mar 01, 2010 5:55 pm
- Location: Cedar Park, Tx
Re: 89' 14t/50t conversion? Who has done this?
Don't forget to yell, "Yut-Ughhh!!" 
1989 3LN1 FZR250R, currently stock.
TTR Ignition Systems
TCI Repair and Ignition Transistor Upgrade
VRR Adaptor Harness
YZF600 TCI Adaptor
Running Light Fuse Carrier
TTR Ignition Systems
TCI Repair and Ignition Transistor Upgrade
VRR Adaptor Harness
YZF600 TCI Adaptor
Running Light Fuse Carrier
- ragedigital
- 4000+ Posts

- Posts: 4153
- Joined: Wed May 07, 2008 9:30 am
- Location: Northwest St. Louis
Re: 89' 14t/50t conversion? Who has done this?
I'm sure that combo would work fine, but high RPMs are necessary to get it off the ground.Brutal Tooth wrote:But I am pretty sure that a 14/50 would pop wheelies w/o high RPMs, wouldn't it?
Thanks for joining and participating in the most "active" FZR Community on the internet!