Differences

This shows you the differences between two versions of the page.

--- remove_the_flywheel [2008/06/02 23:42] – 67.166.244.247
+++ remove_the_flywheel [2020/10/19 11:51] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-FIXME
 ==== How to Remove the Flywheel ====
-  * Time: 30 minutues
+**Time:** 30 minutues \\
-  * Required Tools: 5mm allen, [[http://www.toolsource.com/motorcycle-flywheel-puller-p-100172.html|flywheel puller]], hammer, socket wrench
+**Required Tools:**
+    * 5mm allen wrench
+    *[[http://www.toolsource.com/motorcycle-flywheel-puller-p-100172.html|flywheel puller]]
+    * Hammer
+    * Socket wrench
+**Directions:**
+  - Use the 5mm allen tool to remove the stator cover (left side of bike)
+  - Remove the bolt in the middle of the flywheel (you may need a breaker bar)
+  - Screw in the flywheel puller (tighten to around 20 Nm or so, as long as its not loose)
+  - Take a hammer and whack the flywheel puller (Careful, don't damage the flywheel)
+  - It may take a few whacks for the flywheel to loosen, it should then just slide right off
+  - After removing the flywheel there should be a flywheel key (a little half moon shaped bit of metal ) that holds it in place, don't lose this.
+{{:flywheel_.png?180|}}{{:flywheel_with_puller.png?180|}}{{:flywheel_removed.png?180|}}
-== Directions ==
+[[http://fzronline.com/forum/viewtopic.php?f=32&t=1096|{{  :comments.gif  |CLICK HERE}}]]
-. Use the 5mm allen tool to remove the stator cover (left side of bike)
-. Remove the bolt in the middle of the flywheel (you may need a breaker bar)
-. Screw in the flywheel puller (tighten to around 20 Nm or so, as long as its not loose)
-. Take a hammer and whack the flywheel puller (Careful, don't damage the flywheel)
-. It may take a few whacks for the flywheel to loosen, it should then just slide right off
-{{:flywheel_.png|}}
+----
-{{:flywheel_with_puller.png|}}
+- icontender
-{{:flywheel_removed.png|}}