Rear wheel dampers

FZR600 Forum

Moderators: Site Director, FZR Forum Moderators

Post Reply
tclayton9
Level 2.5
Level 2.5
Posts: 261
Joined: Thu Mar 28, 2013 5:32 pm
Location: Roxboro, NC

Rear wheel dampers

Post by tclayton9 »

I lost my rear wheel dampers that sit under the cush drive and I found some used ones on ebay for 15 dollars. Can I go with used ones, or its best to buy new ones?
User avatar
pefrey
Level 5.5
Level 5.5
Posts: 573
Joined: Sat Feb 21, 2009 4:20 pm
Location: Park Ridge, NJ

Re: Rear wheel dampers

Post by pefrey »

You can go with used, but buyer beware as with most stuff. Although unlikely, they can wear out. More likely is that they become brittle and lose their damping quality.

I may have a set of dampers form a 97 FZR 600 that you can have for shipping. Do you want me to check if I have them? I'm 90% sure I do.
tclayton9
Level 2.5
Level 2.5
Posts: 261
Joined: Thu Mar 28, 2013 5:32 pm
Location: Roxboro, NC

Re: Rear wheel dampers

Post by tclayton9 »

I bought one set off of ebay. They looked good but one is missing the rubber pointed pin to hold it to the wheel. It just sets in the wheel. Can I still use it?
DonTZ125
Moderator
Posts: 2214
Joined: Tue Dec 02, 2008 11:20 pm
Location: Scarberia, ON
Contact:

Re: Rear wheel dampers

Post by DonTZ125 »

Yes; the pin is just there to hold it in place when assembling the wheel. A bit of axle grease (which you should be using anyway) will help prevent it from exploring new frontiers.
tclayton9
Level 2.5
Level 2.5
Posts: 261
Joined: Thu Mar 28, 2013 5:32 pm
Location: Roxboro, NC

Re: Rear wheel dampers

Post by tclayton9 »

yes I learned my lesson with axle grease. I had to cut my swingarm in half to get my wheel off. The axle and spacer rusted and joined forces.
Post Reply