Cosmetics and suggestions fzr 400 3en2

[fzrowner1]

really REALLY silly question i though they was rubber? cheers

[GreyImport]

They are on the 250

Theres a rubber joint between the carb and inlet....no 3

http://www.partzilla.com/parts/search/Y ... parts.html

[Evilchicken0]

Those 2 links are for the older Genesis 1wg not the 3en2.

[fzrowner1]

there metal they have duct tape round them? i must have an air leak somewhere cause its revving itself just changed air filter any ideas? thankyou

[GreyImport]

Wonder what part no. the duct tape is.....?

Pull off the carbys and the inlet manifolds and look very very closely at what condition they are in.

Heres the 3EN2 parts diagram.....



And heres a 600 parts diagram....

http://www.partzilla.com/parts/search/Y ... parts.html

[fzrowner1]

must have been forgotten lets call it number 20? haha and where else could there be an air leak? without having to take the bike to bits to much? cheers

[GreyImport]

If u have rubber inlet manifolds then they will surely be cracked and crazed from heat and time......and the only way to tell is by pulling them off and manipulating them to see if they have cracked right thru.....mine were in bad shape but none had split thru to the inside.

[fzrowner1]

they are metal they just had duct tape round them! would you still say take em off? it just revs itsself and does not drop revs they drop really slowly! could it be anything else? would be nice for it to tick over nicely and i cud let it warm itself up at the moment i have to sit on it and wait! very annoying cheers

[GreyImport]

There has to be rubber there either way ...and having duct tape anywhere would be ringing alarm bells to me.

By pulling them off u can check for cracks ,leaks or wateva .... the carbs or the rubber joiners may not be seated correctly or the clamps may be loose or shot.

If u own an FZR get used to carby removal

Be careful not to drop anything down the holes including your false teeth.

[Evilchicken0]

The 3en doesn't have metal inlets they are one piece rubber. well rubber outside either way they should be black all over and one piece.

Buy these http://www.ebay.co.uk/itm/Yamaha-FZR-40 ... 3cce215c50 be quick you might not get another chance.

::Jedi on:: These are the 3en inlets you are looking for ::Jedi off::

[fzrowner1]

evil chicken you my friend have just become god just paid for them!! thankyou so so much
and mr greyimport im only 19 what false teeth haha thankyou guys!! oh i found a guy on ebay last week just paid 35quid for carbs bar ends anotherset of clip on bars and electrics off bars for 35quid!! inc postage having a good month! thankyou again people!!