Hey all, i recently cleaned the carbs on my bike ( was startting to run choppy after 1/2 throttle) Now i finally got it back together, all the cables hooked up etc. First of all the right two carbs butterfly valves open much before the left side carbs. The left two carbs dont open up until about 1/4 throttle, im guessing this is my main problem. Im also guessing that this has to do with the syncing of the carbs. Would there be any way to do it without the carb sync tool, just to get the bike to run and drive? or do i 100% need that tool?
Any other advices or tips is greatly apprecited, thanks guys!!!
Cleaned carbs.... now carb sync?
Moderators: Site Director, FZR Forum Moderators
-
JasonRDfan
- Level 2.0
- Posts: 239
- Joined: Fri Jul 06, 2012 6:15 am
- Location: Pittsburgh, PA
Re: Cleaned carbs.... now carb sync?
Did you check the pilot adjustment screws? They are known to move in and out.
92 fzr600 Vance & Hines edition, galindo f1 grips, Vance & Hines super sport complete exhaust, oem clutch with Vance & Hines springs, Piaa horn, Hella headlight, Vance & Hines power pak, passenger seat cowl, 07 r6 regulator, ballistic evo2 8 cell, JT 14 tooth sprocket, Joe Florida sportbike multi-color led kit, galindo bar ends,
Re: Cleaned carbs.... now carb sync?
Synching the carbs is pretty easy without the tool. However, I believe you are supposed to check valve clearances / adjust the valves first.
Once that is done, I think there is a write-up in the Wiki about synching the carbs.
Once that is done, I think there is a write-up in the Wiki about synching the carbs.