Help with float chamber line please

FZR400 Forum

Moderators: Site Director, FZR Forum Moderators

Post Reply
buzzawak
Level 2.0
Level 2.0
Posts: 201
Joined: Wed Apr 29, 2009 4:09 am
Location: Newcastle, Australia

Help with float chamber line please

Post by buzzawak »

HI all,
I do not have the "Float Chamber Line" marked on my carbies to set the float level.
Could someone with a set of carbies that have the line marked please provide to measurment for me?
I need measurements for A, B & C
Thank you
Image
Top
User avatar
ragedigital
4000+ Posts
4000+ Posts
Posts: 4153
Joined: Wed May 07, 2008 9:30 am
Location: Northwest St. Louis

Re: Help with float chamber line please

Post by ragedigital »

Your line might be where the cover makes the angle.

This might help a little. You can see the float level line on the float bowl covers in a pic I took of my FZR400 carbs when I had them:

Image
Thanks for joining and participating in the most "active" FZR Community on the internet!
Top
User avatar
cad600
1000+ Posts
1000+ Posts
Posts: 1413
Joined: Fri May 09, 2008 3:41 pm
Location: Atlanta, GA

Re: Help with float chamber line please

Post by cad600 »

And if they are not on the back cover, look at the side of the carb body.
Yes, that is a Single Sided Swingarm FZR600 that I built.

Something is lurking, waiting, wanting to be built......It calls to me from the darkness....

I can finally see the light at the end of the tunnel....Then I realize that it is the train coming to run my ass over....
Top
buzzawak
Level 2.0
Level 2.0
Posts: 201
Joined: Wed Apr 29, 2009 4:09 am
Location: Newcastle, Australia

Re: Help with float chamber line please

Post by buzzawak »

Thanks cad600, Yea looks like your right
Thanks again
Buzza
Top
Post Reply

Return to “FZR400”