New chain question

FZR600 Forum

Moderators: Site Director, FZR Forum Moderators

Post Reply
User avatar
FzrAtx
Site Newbie
Posts: 43
Joined: Sat Apr 04, 2009 5:52 pm
Location: Austin, Texas

New chain question

Post by FzrAtx »

Hey guys this is probably a dumb question, but I have gotten mixed answers so I figured I would ask. When you get a new chain do you need to get new sprockets even if the old ones look fine??? And is there a huge difference between an RK chain and the chep ones?
Image
96 Fzr600, YZF front end, D&D exhaust, R6 front calipers & master...
saving up for tank/tail conversion, maybe swingarm too
sweekster
2000+ Posts
2000+ Posts
Posts: 2773
Joined: Tue May 13, 2008 10:52 am
Location: Perris, CA

Re: New chain question

Post by sweekster »

Some will say yes..some will say it doesn't matter. I'm one of those people who say "If you put on a new chain you should put on new sprockets front and rear". Just helps with wear and sets a baseline you can follow. They all wear the same and you will know how long you have before you need to swap in a new set. In my opinion, as long as the chain meets exceeds the tensile strength that is required for your engine size than the brand name doesn't matter. But there is definite debate about that.
Duane...
Bike:
1994 Yamaha FZR 1000 EXUP
Factory Pro Stage 1 Jetting | K&N Filter | Corbin Seat | ProTek Keyless Gas Cap | GSXR Mirrors
My Thread
Cage:
2005 Saab 9-7x 5.3i Arc AWD

Image


THE WIKI IS YOUR FRIEND
THE SEARCH IS YOUR SIGNIFICANT OTHER
USE THEM!!
User avatar
95FZR600
2000+ Posts
2000+ Posts
Posts: 2972
Joined: Sat May 31, 2008 10:41 pm
Location: Kennesaw, Georgia

Re: New chain question

Post by 95FZR600 »

I have always been told to replace sprockets when you replace the chain but I dont always do it. Inspect the sprockets and if they look like they need replaced then......replace.
2002 Yamaha R6-----2003 Yamaha R6

Image
yamaha_george
5000+ Posts
5000+ Posts
Posts: 5853
Joined: Fri May 09, 2008 8:46 am
Location: west london UK

Re: New chain question

Post by yamaha_george »

FzrAtx wrote:Hey guys this is probably a dumb question, but I have gotten mixed answers so I figured I would ask. When you get a new chain do you need to get new sprockets even if the old ones look fine??? And is there a huge difference between an RK chain and the chep ones?
Hi,
the dealers will always tell you change everything cause they make more cash.

HOWEVER if you use common sense and clean and inspect your sprockets before using them with a new chain fine I have serviced bikes & machinery for almost half a century and i have done both as the inspection dictated.

back in the "old Days" it was probably because sprockets were of softer steel & case hardened for better longevity and once that VERY thin layer was worn thro then the sprocket died a VERY quick death
User avatar
FzrAtx
Site Newbie
Posts: 43
Joined: Sat Apr 04, 2009 5:52 pm
Location: Austin, Texas

Re: New chain question

Post by FzrAtx »

Thanks everyone.
Image
96 Fzr600, YZF front end, D&D exhaust, R6 front calipers & master...
saving up for tank/tail conversion, maybe swingarm too
User avatar
FzrAtx
Site Newbie
Posts: 43
Joined: Sat Apr 04, 2009 5:52 pm
Location: Austin, Texas

Re: New chain question

Post by FzrAtx »

Does this chain look like a good deal???
http://tinyurl.com/dxgzmx
Image
96 Fzr600, YZF front end, D&D exhaust, R6 front calipers & master...
saving up for tank/tail conversion, maybe swingarm too
User avatar
mossy1200
Level 5.0
Level 5.0
Posts: 535
Joined: Thu Feb 19, 2009 11:27 pm
Location: Wellington New Zealand

Re: New chain question

Post by mossy1200 »

My advice is if you dont get new sprockets then dont get the dearest avaliable chain.
Go for cheeper chain on old sprockets(assume they look good)or full set if installing dearer chain.
the cheeper chains are ok but lube them as often as possible because there ability to keep dust and road grit out of the rollers is not as good.

Image
Post Reply