3en1 swingarm question

[kracksmith]

I am planning to purchase a 3en1 braced swingarm for my US FZR400 89.

Is this a direct bolt on or I would need spacers? anything else such as a FZR600 brake bracket??

thanks

[cad600]

Take a look at Yamaha_George web site. He has information there about doing this swap onto a 600 as well as the 3TJ swingarm. He also says that the swingarm pivot width is the same for all FZR400's and the 3HE FZR600. I think the problem is going to be the pivot bolt and the axle. The axle will be a non-issue if you use the matching wheel for the swingarm.

[yamaha_george]

Take a look at Yamaha_George web site. He has information there about doing this swap onto a 600 as well as the 3TJ swingarm. He also says that the swingarm pivot width is the same for all FZR400's and the 3HE FZR600. I think the problem is going to be the pivot bolt and the axle. The axle will be a non-issue if you use the matching wheel for the swingarm.

CAD,
Thanks Man, for indepth look at the swap and the Gotcha's and my solutions see:-


http://www.saltmine.org.uk/fzr/swingarm.html

&


http://www.saltmine.org.uk/fzr/3tj-mod.html

The notes in the latter refer to seperate GOTCHA's re use of non stock shocks

If you have any questions I may not have covered PM me

[pefrey]

I posted some answers to your questions here:
http://www.fzrarchives.com/ipb/index.ph ... opic=44219