Will this can fit?

Any topic relating to the FZR/YZF (UK) or motorcycling in general.

Moderators: Site Director, FZR Forum Moderators

Post Reply
User avatar
jeremy
50+ Posts
50+ Posts
Posts: 60
Joined: Thu May 15, 2008 10:43 am
Location: Toronto, Ontario. Canada

Will this can fit?

Post by jeremy »

Will a Yoshimura RS3 slip on from a FZR 400 be a direct bolt on for the 600?

Thanks!
Top
User avatar
95FZR600
2000+ Posts
2000+ Posts
Posts: 2972
Joined: Sat May 31, 2008 10:41 pm
Location: Kennesaw, Georgia

Re: Will this can fit?

Post by 95FZR600 »

You know :headscratch: , Not sure. If its a slip on it should.
2002 Yamaha R6-----2003 Yamaha R6

Image
Top
User avatar
the_finch
Level 8.5
Level 8.5
Posts: 882
Joined: Tue Jun 03, 2008 8:06 pm
Location: Midland City, AL / UAHuntsville, Huntsville, AL

Re: Will this can fit?

Post by the_finch »

I have a Yoshi RS-3 on my bike. The important thing is to make sure that the inlet on the the midpipe is 2" inside diameter (id). The stock FZR600 header has a collector outlet size of 2" outside diameter (OD).
Hope that helps. my2cents
Image
1997 FZR600RJ

Engine: K&N Drop-in air filter - stock airbox - FP 5°ignition advancer - EBC "Street Racer" Kevlar clutch
Exhaust: Stock header - Yoshimura RS-3 Carbon fiber slip-on
Body: Original paint/graphics - Clear Alternatives integrated LED Taillight - Flanders' flush front signals - YZF600 Mirrors - Comp. Werkes Stainless fender eliminator/tag bracket - 60w/55w H4 headlights
Tires: Metzler MEZ4B 120/70 ZR17 Front - Michelin Madacam 100x 150/70 ZR18 Rear
Brakes:Stock rotors with EBC HH Sinstered pads
In the works: YZF600 header, '97 Bandit 600 rear wheel, DynoJet Stage 3, Racetech Springs and Emulators fork rebuild, FZ1 rear shock, YZF600 front MC, Galfer SS Lines, CFM rearsets
Top
bweight
Level 4.0
Level 4.0
Posts: 421
Joined: Wed May 07, 2008 4:03 pm
Location: Sudbury, ON, Canada

Re: Will this can fit?

Post by bweight »

I"ve got an 89 400 with stock headers and a V&H SSR Slip-on from a 600.. Now, the header outlet was a little smaller than the OD of the slip-on so I just brought the 2 pieces to a local muffler shop and had them expand the header pipe a little bit to accomodate the slip-on.. It fit perfectly and I've got no issues with it.

Now, in your case I'm assuming that the 400 slip-on will be slightly undersized for the 600 headers, so you'll just have to have the slip-on opened up a little bit.. Other than that, I don't see why you'd have any issues with it.
89 FZR 400
Custom Paintjob
600 plastics.
06 - R6 Shock
FZR600 Motor
Polished Frame & Engine Covers

Soon to be:
Broke........

Image
FZROnline.com Decals. Get yours Now!!!
Top
Post Reply

Return to “General Discussion”