===== Home made 2 Bottle type carb sync tool =====

Postby **Shredex »**

 Sat Feb 28, 2009 

If you are thinking about building a carb sync tool, then I would recommend using the 2-bottle method.
I just used it and it works wonders! SUPER fine tuning...My bike revs so smooth now. it sounds so beautiful.Iv tried the stick and tubing method, all [[http://www.pokerenfrancais.eu/telechargement-poker/|telecharger poker]] I can say is, it sucks and you can risk sucking liquid into your motor.

==== Material List ====

2 off GLASS bottles (I used two 9.5oz Starbucks Frappuccino bottles) NOT plastic bottles

12Ft of 3/8"-1/4" clear pvc tubing (the outside is 3/8", and the inside is 1/4")

1 off 3/8" sharp metal drill bit

2 off rubber stoppers OR rubber chair leg plugs/bumpers (I used 1.5" chair leg plugs)

4 off 6mm mig welder tips (there is ten in a pack)

=== optional ===

2 off "Y" connectors that fit the 1/4" tubing.

2 off 1/4" rubber caps

# Zip-ties as required

=== Pictures ===

{{:synch-1.jpg|}}

{{:synch-2.jpg|}}

{{:synch-3.jpg|}}

{{:synch-4.jpg|}}

{{:synch-5.jpg|}}

{{:synch-6.jpg|}}

Thanks to CAD600 for his photo's of how he did it

This one below is Sweekster finish tool

{{:synch-shredex.jpg|}}

**//__Thanks to both Sweekster for his Photo & write up & CAD600  for his detailed photo set__//**
Edited by **Y_G**