==  Synch Tool Design  == 
Sent:- Sat Nov 13, 2010    


From: **fizzer6hundred**

I built this:-


[[http://fzronline.com/gallery2/main.php?g2_view=core.DownloadItem&g2_itemId=20862&width=113&height=150]]  


 and here are the details:

Material:
7 ft per cylinder total (28 ft) 5/16 in OD 3/16 in ID vinyl tube

4 off  6mm brass welding tips
Wood molding with 4 channels to lay the tube in (found at Lowes)

Recommended marvel Mystery oil or some other high viscus oil 3 oz?

2 off "T" 5/16 in couplers (I used 1/4 in and that worked fine)

2off inch length of 3/16 hose to connect the remaining unions together

=== Instructions: ===

Cut EQUAL lengths of tube 6 or 7ft (either will be just fine)

Drill 4 hole in the top and 4 holes in the bottom of the wood molding

Paint wood white LET IT DRY THOROUGHLY

Mark lines with a T-Square as desired for reference

Pull PLASTIC lines through holes

Connect all lines at bottom of the tool  ( properly called a **Manometer**) with T's and extra 2 inch tube

Super glue the lines to the wood (make sure paint is dry)

Add oil at the bottom end using a plews type liquid pump if you have one, otherwise gravity feed

**have fun with your new tool** 
                // Fizzer6Hundred //

== word of caution do not EVER let the bike pull oil out of the tool into the engine it will cause damage !!==