Hi. I have a 1985 FZ750/1000 HYBRID I built around 1993...

[shredex]

finch, thats the style that wont work.
that style mounts to where your stay/birdcage mounts and the other end mounts to this adaptor on the clip-ons.
Iv got the same thing but from an 04-06 r1. but at least i have the clip-on part covered.
was planning on making the stay mount plate -for the r1 front conversion I did- solid and drill and tapping it on the top to accomidate the stabilizer.
I have the one that mounts to the fzr.
look up some older ones.

[nickate]

I think I need one FZspecific... Not FZR.
Shred.. if you do indeed have a bent up one for an FZ (steel frame) I would be a buyer if you're a seller! It must have the correct bracketry for both the fork as well as the frame though. Thanks again for straightening out my pic catastrophe.
Tom

[shredex]

what is the diameter of your fork tubes?
I believe fzr has 32mm.
the stabilizer I have clamps onto the fork tube and the other end mounts to the frame side.
as long as the stabilizer is 24cm or longer(longer prefered) then you should be good.

[nickate]

Measured fork tube= 38mm.

Got carbs back together this morning... Gonna put 'em on and see if'n it runs.

[nickate]

IT RUNS!!! Holy crap it's as loud as I remembered it being...
It has a Krecker small baffle header that I cut and welded to fit the FZ Chassis. I also made s quiet slip-on from a 900RR muffler can but the bike was almost a half second slower with it if I remember correctly. but it was real quiet.


Idles@1000rpm and has instantaneous off idle throttle response. BOOM... RIGHT NOW.

Now to re-assemble the front fairing and get it down the road...

Maybe tomorrow a ride to see how bad the trans is.... Yee-haw....

[sweekster]

PS. REALLY NEED TO FIND A STEERING STABILIZER/ DAMPNER.... Anybody got a sugg?

Click here