Hi,
New to this forum but hope you can help.
I'm looking for some shims to reset my valve clearances after a cylinder head overhaul.
These shims are not the flat type as per FZR100, but a bucket type that sits on top of the valve stem.
If anyone has any of this type of shim, or knows of a source for them, please let me know.
Thanks
ajb235
1988 FZR750 Yamaha 2LM model
FZR750 tappet shims
Moderators: Site Director, FZR Forum Moderators
Re: FZR750 tappet shims
Hot Cams doesn't seem to offer for this model. Dealership might be the only option.
Yes, that is a Single Sided Swingarm FZR600 that I built.
Something is lurking, waiting, wanting to be built......It calls to me from the darkness....
I can finally see the light at the end of the tunnel....Then I realize that it is the train coming to run my ass over....
Something is lurking, waiting, wanting to be built......It calls to me from the darkness....
I can finally see the light at the end of the tunnel....Then I realize that it is the train coming to run my ass over....