Carb sync fittings
Posted: Thu Jun 12, 2008 10:04 pm
So i made a carb sync tool out of two bottles and 1/4 tubing BUT now i need fittings for the intake boots. Any ideas?
FZRSupport: the FZROnline Archive
Carb sync fittings
Page 1 of 1
Re: Carb sync fittings
Posted: Sun Jun 15, 2008 11:19 pm
Don't you guys sync your carbs?
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 12:37 am
I bought a very carb tool for that purpose. I split it with zero so it was only 55. Now I get super carb tuning ability. I believe you can get 6mm grease fittings from lowes/home depot/ace wherever and drill out the center. Then you use those. I think it's 6mm at least.
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 9:17 am
You can buy 6mm fittings from Motion Pro.
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 11:57 am
That too, but I was saying the cheap way.gooserex wrote:You can buy 6mm fittings from Motion Pro.
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 1:52 pm
mig welding tips 6mm, IIRC.
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 2:11 pm
we (buddy did the work, i watched) MacGyvered up a set by drilling out a couple 6mm bolts and tigging about an inch of (Aluminum?) tubing to the bolt heads. Worked like a champ.
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 2:39 pm
Travis wrote:mig welding tips 6mm, IIRC.
I've heard this too....
Re: Carb sync fittings
Posted: Mon Jun 16, 2008 5:50 pm
interesting..never would have thought of that. thanksTravis wrote:mig welding tips 6mm, IIRC.
Re: Carb sync fittings
Posted: Sat Jul 19, 2008 7:40 pm
Travis, I went out and bought some of those mig welding times and they worked great! Thanks a ton man. Only cost 7 bucks and I got 10 of themTravis wrote:mig welding tips 6mm, IIRC.
