FZRSupport: the FZROnline Archive

does anyones work?
After studying my steering lock problem, and noticing that the bolt is to low by 1/16"
all I had to do was adjust one of the spacer on the triple trees which raised the top section with the ignition. Now it works!!
Yay!! not ther is a whole 10% less chance of someone stealing my bike from the original 95%...

shredex wrote:does anyones work?
Id like to make mine work but I have no clue how.
is it something easy to fix?

S,
mine works, most times the bolt bit gets bent or the hole in the frame gets burred.
judicios use of a file usually sorts it our

yamaha_george wrote:
S,
mine works, most times the bolt bit gets bent or the hole in the frame gets burred.
judicios use of a file usually sorts it our

my key also wont come out when I turn it to steering lock.
i think the whole system might have been removed from my bike, not sure. Ill have to take a look again

oh, i see, its off center.
the bolt is about 1/8 inch to low, so it doesnt go into the frame hole

i think ill have to grind down the ignition mount so its set higher and will meet with the hole

Mine works, although my key is so worn I can take it out with the engine still running

Fartblood wrote:Mine works, although my key is so worn I can take it out with the engine still running

Mine too.I find it convenient,I can pull the key out and check my gas while riding

FasterThanUr wrote:

Fartblood wrote:Mine works, although my key is so worn I can take it out with the engine still running

Mine too.I find it convenient,I can pull the key out and check my gas while riding

my tank takes a seperate key so I can too

shredex wrote:

FasterThanUr wrote:

Fartblood wrote:Mine works, although my key is so worn I can take it out with the engine still running

Mine too.I find it convenient,I can pull the key out and check my gas while riding

my tank takes a seperate key so I can too

+1! My buddy's '68 El Camino does that with the ingition. I thought it'd be nice cause then you'd never accidentally leave your key in the ingnition.

Mine dont work either.

Mine works oddly enough if I turn it far enough my hazards come on!

mine works!

Fartblood wrote:Mine works, although my key is so worn I can take it out with the engine still running

yup, we've got a pickup that does that, very convenient!

mine worked the last time i used it but i rarely ever use it so ......

I tried getting mine to work couple weeks ago but no luck.

inspired by this thread i checked mine again and sure enough it works just fine