FZRSupport: the FZROnline Archive

I was gonna swap out the rear wheel on my 600 for a FZR400 wheel (lighter weight), and wanted to do the same to the front. I just wanted to check and make sure I can use my same speedo drive, brake rotors, etc. with the 400 front rim in the stock FZR600 forks (1997).

I tried to search the forums in order to check, but I can't seem to get it to display any results, as it says "400 wheel swap" is too common to display the results.

I did this with my fzr all the 600 stuff swaps straight onto the 400 front wheel.

The rear wheel is a little more difficult you need to use the 400 disc as the 600s disc is completely different. That also means that you must use the 400 caliper and caliper bracket. You also need a 400 sprocket and 400 wheels spacers from memory, other than that it fits.

dru86 wrote:I did this with my fzr all the 600 stuff swaps straight onto the 400 front wheel.

The rear wheel is a little more difficult you need to use the 400 disc as the 600s disc is completely different. That also means that you must use the 400 caliper and caliper bracket. You also need a 400 sprocket and 400 wheels spacers from memory, other than that it fits.

DRU,
that is certainly true of the 3EN rear wheel swap nothing from the 3HE 600 fits unless you want to make brake tie rods:-
see http://www.saltmine.org.uk/fzr/swingarm.html

Been looking at a wheel swap for my '91 3HE racebike too, as I need to go down to a 17" rim to get slicks for it.

How easy is a Thundercat rear wheel to slot in?

ZXRRDave wrote:Been looking at a wheel swap for my '91 3HE racebike too, as I need to go down to a 17" rim to get slicks for it.

How easy is a Thundercat rear wheel to slot in?

Click here

and click here