Page 1 of 1
Rear wheel dampers
Posted: Wed Jul 30, 2014 6:51 pm
by tclayton9
I lost my rear wheel dampers that sit under the cush drive and I found some used ones on ebay for 15 dollars. Can I go with used ones, or its best to buy new ones?
Re: Rear wheel dampers
Posted: Mon Aug 04, 2014 9:29 am
by pefrey
You can go with used, but buyer beware as with most stuff. Although unlikely, they can wear out. More likely is that they become brittle and lose their damping quality.
I may have a set of dampers form a 97 FZR 600 that you can have for shipping. Do you want me to check if I have them? I'm 90% sure I do.
Re: Rear wheel dampers
Posted: Thu Aug 21, 2014 7:05 pm
by tclayton9
I bought one set off of ebay. They looked good but one is missing the rubber pointed pin to hold it to the wheel. It just sets in the wheel. Can I still use it?
Re: Rear wheel dampers
Posted: Sat Aug 23, 2014 10:42 pm
by DonTZ125
Yes; the pin is just there to hold it in place when assembling the wheel. A bit of axle grease (which you should be using anyway) will help prevent it from exploring new frontiers.
Re: Rear wheel dampers
Posted: Sun Aug 24, 2014 8:37 pm
by tclayton9
yes I learned my lesson with axle grease. I had to cut my swingarm in half to get my wheel off. The axle and spacer rusted and joined forces.