FZRSupport: the FZROnline Archive

So ive just completed my 660 build. Rode to work one day. And down the street and back. Havent really got into it hard yet. No insurance but ill have some today. Has anyone. Else done this mod and what do you think of it?

Anyone?

Yeah, I have. wrote it up here.

viewtopic.php?f=8&t=9660&hilit=660+the+easy+way

It's nice bang for the buck for sure.

Ive read your post a million times. Lol. But you have cams and head work. Cant do all that right now. How is it holding up? Any new issues?

Due to the crazy ass winter we've had, despite the dry roads and diminishing snow, I still have a 2 foot ice dam in front of my garage door. So, it has not been out thisyear yet. Lots of salt dust on the roads still, too...

So, no issues this year.

Had loads of fun the last couple summers. Rear tire is the big issue now that my gave Avons arent available anymore.

You do yours by re-sizing the rods?

Yeah its been a bad winter here. Obviously not as bad as yours . Yeah i used my fzr rods. Stock head. Full v&h exhaust. Stage. 3 factory pro jet kit. Roads were wet the ladt time i rode. Today ill see what its got on my way to work.

Wheel spin taking a toll on your tire?

The ride to work today was fun. Definitely more pep. Love it. Could be the cold air but i might have some cwrb tuning in the near future. Cruising to throttle kinda hesitated for a sec then took off.

JeCarter wrote:Wheel spin taking a toll on your tire?

a) Yes, it can and does.

b) lack of good 18" rear tire options...I love teh Avons...can't get em anymore.

c) afraid the shinko will suck, especially with more HP.

Is there anything we can do to prevent wheel spin. Suspension?

Right wrist?

So what youre saying is not so much throttle correct? Wouldnt that slow you down? Lol

If your rear is lit up, you ain't accelerating - at least, not in the direction you want!

hello im a new member here but i was just riding my freshly built 660 around today which inspired me to check some forums this evening i finished putting mine together last november and today was the first time i actually put any real miles on it. i had the rods honed to fit the yzf piston pins fyi. any questions i can answer i will

Few problems...
On take off it hiccups then takes off.
If i pull in clutch from cruise it dies but doesnt if i run rpms down before clutching.
Steady cruise to throttlw hiccups too.
Any ideas?

Does it run better with the choked engaged?