Page 1 of 1
Mikuni round main jet size
Posted: Thu May 16, 2013 5:41 pm
by Hamaya
After reading Factory Pro's CV carb tuning guide, I'd like to try going up another main jet size. When I go to BikeBandit's website, I see they have options for
large round main jets,
small round main jets, and
round main jets. Which is the correct size, or doesn't it matter?
Thanks.
Re: Mikuni round main jet size
Posted: Thu May 16, 2013 10:56 pm
by ragedigital
Not sure what carbs those are for. Stick with FZR600 specific Factory Pro or DynoJet jets. You can usually order them direct from their respective websites.
darrin
Re: Mikuni round main jet size
Posted: Fri May 17, 2013 12:39 pm
by Hamaya
After going on Factory Pro's website (how can such a well known company have such a headache-inducing website? But I digress...), I found this page about
ordering individual jets. It gives the "small, round, slotted" jet diameter to be 6mm. I just measured the stock jet diameter to also be 6mm, so I guess the FZR600 uses the small round size.
The jets in the Factory Pro kits are manufactured by Mikuni, so they should be the same as the ones on BikeBandit.