FZRSupport: the FZROnline Archive

Hey guys, its me again, I just arrived home from a ride, and my charging was not so good, so I fixed that but than I saw this thing something in the rear I don`t know what is it, whats called, or what it does, please help, its in the back/tail of the back, it is connected the the indicators and the brake light. And it has 2, one just broke down. Please help.

Do you have LED turn signals? It looks like its a resistor so the turn signals flash at a normal rate.

^^ That sounds about right.

Nope I don`t have LED turn signals they are normal with light bulbs in it.
So that means I could take them out ? or should I leave it there ?

That's weird. It's not stock that's for sure. Is there current running through it when the bike is on? Does it make 1/2 of the brake light blink like a turn signal?

It has a blink when I pull the front brake in, it blinks than in stays on, I don`t know what to do with it, and I think it steals power from my battery, not sure.

first up the item is a 17 watt ceramic resistor and not a stock component. From the pictures it only connected at one end. These have a wire at both ends to complete a circuit so this one is not drawing any current. I have no idea why it's there.

Check which wire they connect to:
FZR 600 schematics are here
FZR 1000 here

In the first picture that one was busted, than my father fixed it, but we don`t know what to do with it, I would really take it down, so the bike would remain kinda stock, at least at the electronic part..

Thanks for the reply`s !Thanks for the Help

It`s connected to the turn signals only a recheck`d it.

In that instance it would be for led lights. If Anything I think it would make your turn lights blink slower, using standard bulbs.

Do a test see what happens when you bypass it.
Sent from my C771 using Tapatalk 2

I will leave it on for a while, or until I need to take off the tail, because it`s a lot to take off. Thank for the replies all of you !