I took out the plug for #3 and it has spark
took off the carbs and cleanned out, reassembled, bench synced it
it starts and idles, but runs ruff. like not hitting on all cyls
spray water on each exaust header and you can tell that #3 is not as hot as the other 3
Is this a elec prob or fuel??
any ideas would be great
just cleaned carbs, but cyl #3 not firing HELP
Moderators: Site Director, FZR Forum Moderators
Re: just cleaned carbs, but cyl #3 not firing HELP
I'm having a similar issue on mine, but mine starts firing under acceleration. When you cleaned the carbs, did you take a fishline and clean out the jets?
Upgrades:
- Barnett Clutch------------------------------------------R6 Blue Dots, Front Master Brake Cylinder+Reservoir
WP Adjustable Rear Shock----------------------------Vortex 520 Conversion with RK GB520GXW Chain
V&H Header (4-1)--------------------------------------Swingarm Spool Mounts
Cobra F1r Exhaust Can--------------------------------R6 Voltage Regulator
Flo-Commander with Remote-------------------------Custom Airtech Passenger Seat
Stage 7 Jet kit with Diffuser Caps--------------------Factory Pro Nickel Emulsion Tubes
Wiseco 630 Kit------------------------------------------Custom Frame Slider Mounts
Modking Hydraulic Clutch Kit--------------------------Hella Projection Headlight with Xentec HID Kit (H9 Bulb)
Modking Aluminum Radiator Overflow Bottle--------
-
cntryboy85
- Level 3.0
- Posts: 305
- Joined: Mon Jun 20, 2011 8:36 pm
- Location: jacksonvill, fl
Re: just cleaned carbs, but cyl #3 not firing HELP
could be dirty jet, or stuck float, possibly could be internal as far as valve might be floating and not holding compression. if you give it gas does it stumble or rev normally?