Cylinder O-Ring Question
Moderators: Site Director, FZR Forum Moderators
-
SquadraCorse
- Site Newbie
- Posts: 42
- Joined: Sun Aug 01, 2010 7:55 pm
- Location: Cumberland RI
Cylinder O-Ring Question
Are the o-rings for the bores (#2 below) necessary for preventing water from slipping by the cylinders and into the crankcase? These don't seem to fit nicely in their intended recess and there is nothing to keep them from falling down over the con rods.
-
kilika2
- 1000+ Posts
- Posts: 1268
- Joined: Thu Sep 24, 2009 2:50 pm
- Location: South East Missouri
- Contact:
Re: Cylinder O-Ring Question
I had to heat mine with a hairdryer a little to get them to fit. Then I used two non sharp screwdrivers to get mine in there. It was a pain.
Chris.
Chris.
Before(5/5/09)_____________After(5/5/10)_____________Way After(8/1/10)
1995 FZR600 Sold
2006 R1 Sold :-\
2009 Buell 1125R
