Pic:
Triangular casting above oil filter
Moderators: Site Director, FZR Forum Moderators
-
mxryder21
- Level 1.5
- Posts: 195
- Joined: Mon May 12, 2008 6:53 pm
- Location: Las Vegas, NV & Gilroy, CA
Triangular casting above oil filter
Can I drill a hole through it? I'm working on a custom lower radiator mount and that is where I plan to fasten the bracket. I know a few guys have used the header studs but the rad sits too low for that to work.
Pic:
Pic:
1993 YZFZR61 ***UNDER CONSRUCTION***
-
fzrbrandon
- Level 7.5
- Posts: 762
- Joined: Mon Oct 06, 2008 3:21 pm
- Location: North Hollywood, CA
- Contact:
Re: Triangular casting above oil filter
Sure, if there's nothing there, why not? IIRC, I used that spot as an anchor for safety-wire on my 400.
92 FZR600 - 3EN2 400 swingarm, Micron, DynoJet, Factory Pro, K&N, R6 shock, RT springs/emulators, R6 MC, Galfer, YZF calipers, Vortex, RK, YZF/R6 VR/R, Vortex, Zero Gravity
90 FZR400 - Sharkskinz, D&D, Sudco, DynoJet, Factory Pro, Ohlins, RT springs/emulators, JEM Machine, Woodcraft, NRC, Galfer, Vortex, RK, YZF/R6 VR/R, Vortex, Lockhart Phillips
89 FZR600 - Vance & Hines, DynoJet, Zero Gravity - sold in '91
http://www.fzrbrandon.com
!!! 400 & 600 Parts For Sale !!! viewtopic.php?f=18&t=9971
-
mxryder21
- Level 1.5
- Posts: 195
- Joined: Mon May 12, 2008 6:53 pm
- Location: Las Vegas, NV & Gilroy, CA
Re: Triangular casting above oil filter
Not really sure why the pic is sideways... I changed it in the gallery "editor" but whatever. I didn't think there would be an issue, especially since the bottom is already kinds bored out but I didn't know if it had some kind of "special significance" or not. I need to get the angle drill and then I'm off to make some aluminum shavings!!!
1993 YZFZR61 ***UNDER CONSRUCTION***