new to fzr600 questions
Moderators: Site Director, FZR Forum Moderators
new to fzr600 questions
I am new to the FZR 600. The person I traded with for this bike said that she believed it would need a top end rebuild and clutch set. The bike has been sitting in the garage for about 5 years. She did not have a key for it. Is there anyway to check the compression without starting it? I know all fluids need to be dumped and etc.. But I dont want to invest the money into the rest of the bike until I hear it run and make sure i will not have to put another engine in it. Any suggestions would be very helpful
Re: new to fzr600 questions
wamearth,
You will have to crank the engine with the starter to check compression. If you do not have a good battery you can use jumper cables from a NON RUNNING CAR OR TRUCK. You will have to figure out how to hot wire it or get voltage to the starter relay. You will need a wiring diagram which you can find here: http://www.fzronline.com/wiki/doku.php?id=fzr600
You will have to crank the engine with the starter to check compression. If you do not have a good battery you can use jumper cables from a NON RUNNING CAR OR TRUCK. You will have to figure out how to hot wire it or get voltage to the starter relay. You will need a wiring diagram which you can find here: http://www.fzronline.com/wiki/doku.php?id=fzr600
Rotortech
Indianapolis, IN
[color=#0040FF][b]1994 FZR 600[/b]
[list]RaceTech Springs
R6 Rear Shock
FactoryPro Jet Kit
Drop-in K&N Filter[/list][/color]
Indianapolis, IN
[color=#0040FF][b]1994 FZR 600[/b]
[list]RaceTech Springs
R6 Rear Shock
FactoryPro Jet Kit
Drop-in K&N Filter[/list][/color]