Ok, swapped upper triple, lights, all that jazz. Everything was working fine. I wired one signal and turned the key on to test it, worked, then boom... nothing. Now I had some loose wires on the other side that I assumed touched and popped a fuse. There's only 4 fuses, correct? If so, they are all good.
I'm kinda at a loss, been on this project since 4pm and this is a major wrench for my tired ass. Any suggestions?
Lost all power
Moderators: Site Director, FZR Forum Moderators
Lost all power
'92 FZR600
Race Tech Springs & Gold Valve Emulators * '06 R6 MC & Calipers * '06 R6 Rear Shock
130 Dynojet Mains/Pods/Flo-Comander * Full Yoshi Exhaust w/ Custom Can
'06 R6 VR * Full OEM Clutch * 14/49 520 Gearing
Seca II Triple w/ Modded Sport Tour Bars * Aztec8 Dual 4" w/ 4100K Halagon lamps * LED Tail/Turn Signals * Vapor Gauges
Lots of Powder
Race Tech Springs & Gold Valve Emulators * '06 R6 MC & Calipers * '06 R6 Rear Shock
130 Dynojet Mains/Pods/Flo-Comander * Full Yoshi Exhaust w/ Custom Can
'06 R6 VR * Full OEM Clutch * 14/49 520 Gearing
Seca II Triple w/ Modded Sport Tour Bars * Aztec8 Dual 4" w/ 4100K Halagon lamps * LED Tail/Turn Signals * Vapor Gauges
Lots of Powder
Re: Lost all power
I'm such a dumbass. It was the main fuse; same one I blew when I crossed turn signal wires last time. 
I just needed a break....
I just needed a break....
'92 FZR600
Race Tech Springs & Gold Valve Emulators * '06 R6 MC & Calipers * '06 R6 Rear Shock
130 Dynojet Mains/Pods/Flo-Comander * Full Yoshi Exhaust w/ Custom Can
'06 R6 VR * Full OEM Clutch * 14/49 520 Gearing
Seca II Triple w/ Modded Sport Tour Bars * Aztec8 Dual 4" w/ 4100K Halagon lamps * LED Tail/Turn Signals * Vapor Gauges
Lots of Powder
Race Tech Springs & Gold Valve Emulators * '06 R6 MC & Calipers * '06 R6 Rear Shock
130 Dynojet Mains/Pods/Flo-Comander * Full Yoshi Exhaust w/ Custom Can
'06 R6 VR * Full OEM Clutch * 14/49 520 Gearing
Seca II Triple w/ Modded Sport Tour Bars * Aztec8 Dual 4" w/ 4100K Halagon lamps * LED Tail/Turn Signals * Vapor Gauges
Lots of Powder