charging system test
Moderators: Site Director, FZR Forum Moderators
Re: charging system test
real simple. check to make sure the battery is at at least 12.6V. if not charge until it is. then run the bike and see if the battery voltage is at 13.5 to 14.5v at 3k rpm. if so then all is good.
Re: charging system test
You can also do a stator check. Here's a web site to help you out.
http://www.electrosport.com/technical-r ... -guide.php
& for those wanting bullet connectors & multi-pin socket/ plugs:-
http://www.electrosport.com/products/ac ... wiring.php
http://www.electrosport.com/technical-r ... -guide.php
& for those wanting bullet connectors & multi-pin socket/ plugs:-
http://www.electrosport.com/products/ac ... wiring.php
2002 Yamaha R6-----2003 Yamaha R6
-
megaloxana
- 2000+ Posts
- Posts: 2282
- Joined: Thu May 15, 2008 5:05 pm
- Location: Hanover, PA 17331
- Contact:
Re: charging system test
'92 FZR 600
Airtech R1 kit \*/ 520 conversion \*/ 14F-47R gearing
K&N pod filters \*/ Stage 3 jet kit \*/ Factory Pro shift kit \*/ Full V&H SS exhaust
Custom '02 R6 undertail \*/ YZF gas tank \*/ Raised via dogbones \*/ custom flush turnsignals
Full R6 brake set-up \*/ SS lines \*/ Progressive fork springs \*/ ZX2 coilpack
ADD YOURSELF TO THE OFFICIAL FZRONLINE GOOGLE EARTH MAP
Airtech R1 kit \*/ 520 conversion \*/ 14F-47R gearing
K&N pod filters \*/ Stage 3 jet kit \*/ Factory Pro shift kit \*/ Full V&H SS exhaust
Custom '02 R6 undertail \*/ YZF gas tank \*/ Raised via dogbones \*/ custom flush turnsignals
Full R6 brake set-up \*/ SS lines \*/ Progressive fork springs \*/ ZX2 coilpack
ADD YOURSELF TO THE OFFICIAL FZRONLINE GOOGLE EARTH MAP
Re: charging system test
There's a list of steps to go through for testing the charging system in the service manual. If you don't have one, I can give you a link to where you can download it.
1995 Yamaha FZR600 (EXUP) - K&N air filter, V&H slip-on, LP smoke windscreen, YZF600 mirrors, BT56SS front, BT010 rear
Re: charging system test
well according to the voltage meter the system isn't charging 
so I'm thinking I need a VR... it was working before all my welding on my subframe so I must have fried it with the welder I had it unplugged for the work but I had 2 little welds to do after it was all assembled and I didn't think it would hurt it to weld with it plugged in for those two welds... guess I was wrong
so I'm thinking I need a VR... it was working before all my welding on my subframe so I must have fried it with the welder I had it unplugged for the work but I had 2 little welds to do after it was all assembled and I didn't think it would hurt it to weld with it plugged in for those two welds... guess I was wrong 
my bikes
-
megaloxana
- 2000+ Posts
- Posts: 2282
- Joined: Thu May 15, 2008 5:05 pm
- Location: Hanover, PA 17331
- Contact:
Re: charging system test
oh man that sucks. Hopefully you can score one cheap. I got a spare R6 VR few months ago for $6 shipped 
'92 FZR 600
Airtech R1 kit \*/ 520 conversion \*/ 14F-47R gearing
K&N pod filters \*/ Stage 3 jet kit \*/ Factory Pro shift kit \*/ Full V&H SS exhaust
Custom '02 R6 undertail \*/ YZF gas tank \*/ Raised via dogbones \*/ custom flush turnsignals
Full R6 brake set-up \*/ SS lines \*/ Progressive fork springs \*/ ZX2 coilpack
ADD YOURSELF TO THE OFFICIAL FZRONLINE GOOGLE EARTH MAP
Airtech R1 kit \*/ 520 conversion \*/ 14F-47R gearing
K&N pod filters \*/ Stage 3 jet kit \*/ Factory Pro shift kit \*/ Full V&H SS exhaust
Custom '02 R6 undertail \*/ YZF gas tank \*/ Raised via dogbones \*/ custom flush turnsignals
Full R6 brake set-up \*/ SS lines \*/ Progressive fork springs \*/ ZX2 coilpack
ADD YOURSELF TO THE OFFICIAL FZRONLINE GOOGLE EARTH MAP