FZRSupport: the FZROnline Archive

Hello.

I have a few FZR600 3HE engine parts for swap. I am after FZR400 3TJ parts really and am prepared to do straight swaps as this stuff is just blocking up my workspace.

What I have:

Oil pump - whole unit
Sump
Crank with rotor on one end and starter gear on the other
4 x 3HE Conrods
3HE cylinder I have got 3 (!?!) pistons. They have 1.0 stamped on the tops - from two strokes I remember this meant 1.0mm oversize but I didnt think oversize FZR pistons were available?????
Camshafts with camchain sprockets on them
Gearbox parts - lots but don't know If I have a whole one.
Completly bare/stripped cylinder head - no valves or anything fitted other than spark plugs and old carb inlet stubs.
Set of paired engine casings with gear selector forks in and gear drum

What I need:

FZR400 3TJ - the wiring that goes between battery and starter solenoid - it also has a little take off wire that goes to the Main fuse.
FZR400 3TJ - front brake lever
W.H.Y?

Dont want to take cash for these parts - would rather swap for 400 parts. If you really need one of these bits and you can collect then come take it!

Chris

there were fzr oversized pistons made for the 400's so don't see why they wouldn't for the 600! i may have a starter solenoid and associated wiringhiding in the shed though i don't need any 600 bits! will have to look tomorrow when i am able to get into the shed. might have a lever, but i think it's a bit scratched iirc!

Thanks for looking would really apreciate the wiring part. I just want to start the bike I have before stripping it down, or at least get it cranking over and not make any rumbling noises!!

Chris

ive got a solenoid, the wiring it has is two short red wires one for battery and another with a connector. and a short thinner wire that attaches next to the red, sorry it's a bit of a rubbish description, i'm having trouble getting a picture onto the computer! (something to do with a three year old and a connecting cable!)

That is exactly the piece of wiring I am after I am not after the solenoid, that is still on my bike. If you want I can paypal you some funds if you like? PM me your paypal email addy and I will reply with my postal address. Thanks for taking the time to look

Chris