Page 1 of 1
Cylinder choice
Posted: Thu Mar 15, 2012 12:24 am
by loganlexow
Ok so I've researched engines and/or options for more power but I can't find out if I can put 600 cylinders and pistons on my 400 to make a 443. This set up would be similar to yzf cylinders/pistons on the 600 bottom end for the 660.
Can anyone shed some light on this?
Sent from my HTC Desire Z using Tapatalk
Re: Cylinder choice
Posted: Fri Mar 16, 2012 10:39 am
by evakat
The 600 piston wrist pins are larger than the 400... so the 600 pistons will not work with the 400 connecting rods...
Re: Cylinder choice
Posted: Tue Mar 20, 2012 1:42 pm
by pefrey
If you are just looking for more power, the easiest option is to swap a FZR600 or YZF600 engine into your bike.
Re: Cylinder choice
Posted: Wed May 30, 2012 3:13 am
by RoadDogma
A YZF600 top-end is possible with machine work. I don't think that you can machine the FZR600 cylinders to the proper deck height. "Easier" is also more cost effective in this case.
