digital ignitor TID14-70 3EN-00

[Whenzy]

Ive got problem with my fzr,the digital ignitor was reached his life and now its totally damaged,and i cant find the same one to
replace on my bike..my bike is fzr 400 genesis exup,1WG..can i use and digital ignitor to run my bike again?what kind of
digital ignitor do i have to find?or do i have to find like my old one?

thanks and any advice will be appreciate..

[Target30]

you are likely going to have to find the same one. i have a couple of 400 ignitions, not sure if they are what you need, probably not, but i'll dig them out and check, just in case.

[ranmafan]

Ignitech has been mentioned before, and they even have instructions specifically for the 400... Looks like you'd lose the EXUP servo, though.

You could also have a look here or try pinging Don for a TCI repair attempt

[ragedigital]

I have a TID14-53R / 1WG-70 available. Left side has 4 flat male prongs / right side has 6 flat male prongs.

Not sure if that's the same model or not.

darrin

[Whenzy]

I have a TID14-53R / 1WG-70 available. Left side has 4 flat male prongs / right side has 6 flat male prongs.

Not sure if that's the same model or not.

darrin

i need TID14-70 3EN-00 / 1WG-70 which has 8 flat male prongs in the right side and 6 flat male prongs on the left side..
this is the exact model i dismantled on my bike..do i have find the same one as i removed or can i do use another model
of igniter box as long as it is for fzr model?
help please,thank you :

[DonTZ125]

Hi, Whenzy.

There's a good chance you'll be able to use Rage's ignitor. If you could do a few checks ...

1. Do you have a separate controller for the EXUP? (Is there a flying connector coming off the ignitor box?)
2. What are the wires and pin-positions on the 8- and 6-pin connectors?