Page 1 of 1
1WG bodywork question
Posted: Sun Jun 30, 2013 7:32 am
by slickwill
Everything was stripped off when I bought my bike. I figured out where the larger brackets on the right go but where do the others go?
Re: 1WG bodywork question
Posted: Sun Jun 30, 2013 7:33 am
by slickwill
Try again.
Sent from my DROIDX using Tapatalk 2
Re: 1WG bodywork question
Posted: Sun Jun 30, 2013 12:00 pm
by tgold
Those two gold-colored 90 degree brackets aren't for mounting bodywork. They bolt to the inside of the frame and there is a cross brace that bolts to it, and the fuel tank in turn bolts to the cross brace.
Re: 1WG bodywork question
Posted: Sun Jun 30, 2013 1:06 pm
by slickwill
Okay, those are spares then. I have that cross brace in place.
I may just make my own mounts since I'm mounting an aftermarket lower.
Re: 1WG bodywork question
Posted: Sun Jun 30, 2013 3:36 pm
by willandrip
The Y shaped bracket is not a fairing mount-may be a coil mount? (Think it is the screen/mirror stay inner mount behind headstock)
The L shaped bracket fixes to a captive nut on the LHS frame rail at the rearmost bottom.
When fixed correctly it virtually obscures the sump plug ;which is why so many new owners ask;" How do I drain the oil?"
Re: 1WG bodywork question
Posted: Fri Jul 12, 2013 10:42 pm
by fzrbrandon
slickwill wrote:Try again.
Sent from my DROIDX using Tapatalk 2
1 lower left (dark one) = horn bracket
2 silverish ones above = tank cross bar mounts to those (as mentioned)
1 in the middle = radiator filler cap (mounts inside the frame on the head tube)
2 dark ones on the right = lower fairing brackets (mount in same place as radiator - IIRC as my track bike doesn't use them)
Re: 1WG bodywork question
Posted: Sun Jul 14, 2013 8:41 pm
by slickwill
Thanks. Though that means they are all spares.