FZRSupport: the FZROnline Archive

hi all new to the forum and fzr's

heres some pics

pics make it look tidier than it is has a few chips etc its got r1 front brake setup, kph - mph conversion and a ART exhaust

what are some other cheapish mods to do?

cheers tommy

check on your voltage reg/rectifier
youmay want to upgrade to a r6 model- pretty easy
could save you some $$$ by not cooking your stater
much info here on the upgrade

Welcome to the madness!

[vulture mode] (ahem) (ahem) VRR Adaptor Harness (ahem)

cheers for the replies guys will be checking that out over weekend can anybody recomend any other mods?

dosent appear to be too many mods for these stunning bikes

tambo wrote:cheers for the replies guys will be checking that out over weekend can anybody recomend any other mods?

dosent appear to be too many mods for these stunning bikes

put a 600 motor in it

Change the headlight lamps for H4 units from a FZR1000 Exup (I think there was a 600 version too), you might want to use a pair of switch relays for this if you use 55/60w bulbs.
Fit a 520 Chain conversion when you change it.
Swap out the shock for an R6 shock, change the front end for a ThunderCat or FZR600R Foxeye (the later uses similar brake discs to your 3EN2) you need to change the dogbones too for +25mm ride height ones.
Consider a 17" rear wheel conversion, use the XJR400 it should drop into the swingarm
Have a check of those front disks, you can swap them for most 298mm yamaha's but make sure they have the smaller hole in the middle (not like the R6) Fazer 600 (old shape) are good because they tend to be younger.

Never heard of a reg rec burning out on these.