Starting my build

[DAP019]

I was curious to know what carrozzeria wheels you have on the bike? I am saving up to get some at the moment and have not found much info on which ones to get. What bike are they originally for? is the rear wheel a 17x5.5 or a 17x6? i am running a later usd r6 setup on the front so that is no issue. i am just wanting to figure out the rear. I would really appreciate your info. thanks bro, Derrick

[DAP019]

Also just wnated to let you know i have a 3tj sp rear swing too.

[Bike_junkie]

The wheel I have is a 17x5.5, it is being mounted in a rrsp swingarm. I believe its off a gsxr600, year unknown. I bought the wheel off craigslist for $175. It had to have a full cm taken out of the carrier and cush drive.

[Kurlon]

Just re-read this thread and caught your note about 3TJ rearsets swapping onto a 1WG. Could you post pics? If they are a decent swap that would imply 1WG units would fit my 3TJ... making spares much easier to source.

[Bike_junkie]

http://www.ebay.com/itm/Yamaha-FZR400-R ... 5af4cd02a1
These are the rear sets I have mounted. To get them to clear the swingarm better I spaced them out 1/4 of an inch. Otherwise they fit just fine. I can't get a picture until next month because I'm out playing army.