FZRSupport: the FZROnline Archive

hey all got a 2 inch lowering link for the wifes bike made by vortex anybody ever install one of these before

What's the eye to eye length?

EDIT:
Thought it was a for sale ad for a sec.


Ya all you gotta do is unload the bike suspension. Thereare several ways of doing this. My preferred method is to get jack stands under the frame rails, or under the foot pegs if there aren't a decent frame rail area on the bike. Once the suspension is unloaded it's a simple matter of un bolting one and replacing with the other.

burns556 wrote:hey all got a 2 inch lowering link for the wifes bike made by vortex anybody ever install one of these before

i dont have any jack stands so i just put a jack opposite the kick stand and jack it up alittle buy the frame all you need is about an inch

well putem in on sat took the lower plastics off and the muffler had just enough room to get the forward bolt out by pulling down on the cat had an engine crane to lift the bike it made it much easiertook about two and half hours including beer