FZRSupport: the FZROnline Archive

Hi All,
I'm looking for a top yoke for a set of FZR600R (Foxeye) forks that will allow Me to use a pair of streetfighter bars. Is anyone aware of another top yoke from a different model that is a straight swap? Forks are 41mm.

Cheers,
Snoo.

I have a Seca II upper clamp that goes onto the FZR for bar risers. $45 bucks shipped. I could potential throw in a set of handle bars too. Let me know if your interested.

Hi Dagan.
I'm from the UK. The Seca is the XJ900? I think that has 38mm forks not 41mm.

The UK FZR600 "Foxeye" would be our YZF600 in the states, so those Seca clamps won't fit.

ragedigital wrote:The UK FZR600 "Foxeye" would be our YZF600 in the states, so those Seca clamps won't fit.

Yes, thanks for clearing that up! Didn't actually realise this was a US forum!

Snoo wrote:Hi Dagan.
I'm from the UK. The Seca is the XJ900? I think that has 38mm forks not 41mm.

Diversion 600 here in the UK, the original model.

Looks possible a top yoke from an early TDM850 may fit. The early ones with the twin round lights were 41mm forks before they went to 43mm with the facelift. I have found someone who says the yoke will fit the Thundercat and the TRX850. Bottom yoke part number for the FZR600r (YZF600R) is the same as those bikes.
Fingers crossed. I'll let you all know if it works as soon as I track one down at a good price (prays to god of E-Bay).

Just to close this thread up. The Mk1 TDM850 Top Yokes fit a treat. And another bit of useful info, the risers for the TDM are the same as the FZX750/FZX700.
Thanks for everyone's help.