Mikuni carb help
Posted: Sun Feb 22, 2015 3:57 am
Hi, I've been given a FZR250 2KR that needs a bit of work - I was told carb needed a clean but closer inspection showed worn seals so I ordered the kit from Litetek but I've come to a stumbling block disassembling the carb and don't know how to fully disassemble it.
If you have a look at the picture,of the three upright cylinders it's the left and centre one I don't know how to remove or what they are but according to Litetek there should be a pilot screw for me to replace the o-rings on - I just can't get to it. In case you haven't guessed it I'm a novice when it comes to this so any other advice of things to do/check while she's apart would be appreciated.. Thanks!
If you have a look at the picture,of the three upright cylinders it's the left and centre one I don't know how to remove or what they are but according to Litetek there should be a pilot screw for me to replace the o-rings on - I just can't get to it. In case you haven't guessed it I'm a novice when it comes to this so any other advice of things to do/check while she's apart would be appreciated.. Thanks!