FZRSupport: the FZROnline Archive

Hi Everyone
Can anyone tell me where to get hold of a lapping tool to grind my valves in or lend me one as can't seem to find one small enough
Thanks Redduke15

http://www.ebay.co.uk/itm/111049290651

You supply the elbow grease! Don't go mad either!

Chris

Cheers Chris
Have seen these but most have a 19mm and 25mm suction cup which is too big

You can use fuel line on the stems to spin teh valves. (do it from the top side). Don't need the suction cup dealio-which in my experience aren't all that hot anyway.

reelrazor wrote:You can use fuel line on the stems to spin teh valves. (do it from the top side). Don't need the suction cup dealio-which in my experience aren't all that hot anyway.

Geeze RR is there nothing new in the world, my uncle showed me that trick when i was 13 and that was just after the dodo bird died out :-}

yamaha_george wrote:

reelrazor wrote:You can use fuel line on the stems to spin teh valves. (do it from the top side). Don't need the suction cup dealio-which in my experience aren't all that hot anyway.

Geeze RR is there nothing new in the world, my uncle showed me that trick when i was 13 and that was just after the dodo bird died out :-}

Old school all the way! People were figuring this stuff out long before I came along and knew it all...