Page 1 of 1
Turn Signal issues
Posted: Sun Jun 29, 2008 3:07 pm
by Ike
So I have been fighting this for a few days and I could jiggle a few wires and it would fix itself, but now it won't. My turn signals work on the right side of the bike but not the left. Is this the relay causing the problems?
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 2:55 pm
by Ike
Haunter I know you are around here somewhere. What do you think could it be my VR causing this or am I just being paranoid because I am to cheap to order the R6 VR yet. I hope its just the blinker box.
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 3:01 pm
by ragedigital
Have you tried hooking up the blinker that works to that side? Make sure it's not something to do with the blinker first.
Basics:
1. Bulb not burnt out.
2. Check for loose connections.
3. Make sure the blinker fluid is the right type and is full.
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 3:04 pm
by Ike
Damn that blinker fluid
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 3:23 pm
by ragedigital
Ike wrote:Damn that blinker fluid
You just never have it when you need it either... LOL2
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 3:30 pm
by sweekster
Ike wrote:Damn that blinker fluid
Make sure it's not silicone based either. It'll get all gummy in the cold and you'll be
for sure.
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 4:39 pm
by Ike
Well my problem actually lied in the new flanders turn signals I got. They are 2 phase and are not cooperating with my normal wiring wired the 2 into on and gave in power and works like a champ now. Im a retard I know. On a side note many more of these emoticons and we will have more of them than wiki topics. But dammit
Re: Turn Signal issues
Posted: Mon Jun 30, 2008 7:32 pm
by haunter
good to see you got it figured out....
I was busy watching Euro 2008 and MotoGP, then I ate a ton since I grilled out and fell asleep on the couch
