Page 1 of 1

devil highmount

Posted: Mon Jun 16, 2008 9:57 am
by PIMPMYFZR
So i found this for sale locally , not trying to bite off modking because ive liked these style pipes ever since i seen them on a bike . But could i make this work and how much fab work am i looking at
Image

Image

they guy is askin 200 for it says its in perfect condition off a gsxr 600

Re: devil highmount

Posted: Mon Jun 16, 2008 11:16 am
by 95FZR600
I do like the look of the high mounts. You should buy them. A few pieces of pipe and a couple bends!

Re: devil highmount

Posted: Mon Jun 16, 2008 11:25 am
by sweekster
Agreed +10. If you can swing the cash then go for it. That'll look really sweet on your bike.

Re: devil highmount

Posted: Mon Jun 16, 2008 11:30 am
by 95FZR600
My buddy at work today mentioned to me that my bike would look great with the exhaust under the tail. If I used the short can under the tail I dont think it would get that hot being titanium. Ill talk to my muffler man. What would you all think?

Re: devil highmount

Posted: Mon Jun 16, 2008 11:53 am
by megaloxana
pimp- go for it man.. It doesn't seem like it would hard at all. The only problem i see is that if you start welding on pipe or bending, you're gonna damage the chrome.

95fzr600- what kind of pipe will you be using under the tail? The one that is currently on your bike?

Re: devil highmount

Posted: Mon Jun 16, 2008 8:35 pm
by 95FZR600
The R1 has dual exhaust under the tail so I would have to look and see if its design is the same as the short can I have. If its shaped different then I could use it under the tail and just have the pipe run to mount it. When I get back from NY I will run it down there. In the mean time I will find a can to fit under the tail.

Re: devil highmount

Posted: Fri Jun 20, 2008 11:02 pm
by modkingfzr600
ok pimp, the pipes will work for sure. and $200 + is the going rate for a set of devil shotguns so the price is right. the mounting will most likely be alot closer than you think, you will probably need some exhaust couplers to cut and weld , or you may be close enough to just cut a slight angle on the end of the mid pipe and weld it to the header . either way , i would make sure it's welded to the header to eliminate any leaks.

Re: devil highmount

Posted: Sat Jun 21, 2008 10:29 am
by megaloxana
So did you buy the pipe or not? :lol:

Re: devil highmount

Posted: Sat Jun 21, 2008 2:34 pm
by PIMPMYFZR
Man this kid replys to me a week later tellin me he got what he was askin for it which was 250. I offered him 200 which was all I was willing to pay even though the 250 he was asking was well worth it also :if it fit slip on . Well I'm gonna continue to find another one just this one was 10 miles away from me ugh lol

Re: devil highmount

Posted: Sat Jun 21, 2008 4:09 pm
by megaloxana
Oh well..you win some you lose some.