I just used it and it works wonders! SUPER fine tuning...
My bike revs so smooth now. it sounds so beautiful.
Iv tried the stick and tubing method, all I can say is, it sucks and you can risk sucking liquid into your motor.
Things you will need:
2 GLASS bottles (I used two 9.5oz Starbucks Frappuccino bottles)
12' of 3/8"-1/4" clear pvc tubing (the outside is 3/8", and the inside is 1/4")
1 3/8" drill bit
2 rubber stoppers OR rubber chair leg plugs/bumpers (I used 1.5" chair leg plugs)
4 6mm mig welder tips (there is ten in a pack)
optional
2 "Y" connectors that fit the 1/4" tubing.
2 1/4" rubber caps
# Zip-ties
Ill have lots of pics in a few days of the whole setup and everything you need to do.
There is a write-up for this on the kawa 250 forum, but I would like to make one for a 4-cylinder bike (FZR).
Ill be working on one to add to the wiki here.
It was Megaloxana that has shown me this method. THanks man
![Thumbs Up! :thumbsup:](./images/smilies/thumbup.gif)