Page 1 of 1
Intake
Posted: Sun May 31, 2009 7:13 pm
by Model192
Intake valve fail, causes a miss at near all RPMs. Black shit coating the intake valve. I'm guessing it died or it's out of spec.
27k miles?
Re: Intake
Posted: Sun May 31, 2009 8:31 pm
by megaloxana
Looks like you FZR'd the valve.
Re: Intake
Posted: Sun May 31, 2009 8:36 pm
by Model192
Abs, 50$ shipped?
Re: Intake
Posted: Sun May 31, 2009 8:58 pm
by reelrazor
What's it's clearance?
Re: Intake
Posted: Mon Jun 01, 2009 9:09 am
by Model192
no idea yet, i broke the plug off in on that cylinder too, so out it all comes
Re: Intake
Posted: Mon Jun 01, 2009 6:41 pm
by reelrazor
Model192 wrote:no idea yet, i broke the plug off in on that cylinder too, so out it all comes
Check the clearances BEFORE you pull the head. Calculate what shims you need with the head mounted...If you check with teh head loose I dunno if it will change as the head is torqued..but it may. And it's just good practice. Shopes that set them (heads) up professionally will use torque plates.
Re: Intake
Posted: Tue Jun 02, 2009 3:41 pm
by Model192
I didn't want to do it that way considering a few of them had junk on them and that one was just f*ck.
A plug was broken off in cylinder 3 so it had to come off anyway. When it's all clean then I'll check it and re-spec them.
What is the range about for stock shims? The downed one has a 181.