FZRSupport: the FZROnline Archive

If you have a good photo of an exhuast for your FZR, please post it here or PM me for uploading details.

I want the following information:

Fits what FZR Models?:
Slip-on or Full System?:
Custom or Manufacturer Fit?:
Brand?:
Still producing?:
Link to manufacturer?:
Cost?:
Stock or Aftermarket Header? (specify):

Thanks!

darrin

Alittle different than most run but i will put it here for those that are interested.

1987 fzr1000, exhaust is factory pipes (i think), came with yosh can. I pulled it because it was way too loud and would burn out the fiber inside every month. A friend got new exhaust for his 98-99?R6 so i snagged his old can and put it on. Its not a perfect fit but close. I think i will do some minpr bending to get it to fit nicely.

http://www.putfile.com/album/129506

Fits what FZR Models?: FZR600 and FZR1000
Slip-on or Full System?: Slip-on (shown) or Full System
Custom or Manufacturer Fit?: Manufacturer
Brand?: Vance and Hines
Still producing?: Yes
Link to manufacturer?: http://www.vanceandhines.com/c102.html
Cost?:
Stock or Aftermarket Header? (specify): Stock




Fits what FZR Models?: FZR600
Slip-on or Full System?: Full
Custom or Manufacturer Fit?: Manufacturer
Brand?: Vance and Hines
Still producing?: Yes
Link to manufacturer?: http://www.vanceandhines.com/c103.html
Cost?:
Stock or Aftermarket Header? (specify): Aftermarket

this is yoshimura rs-3 oval exhuast slip on
price range from $270-$329 depending on where u get it


and if anyone is interested in it for a project of any sort PM me

the pipe in my pic below is a yoshimura R&D slip on exhuast , dont kno the price range for it as it came with my bike when i purchased it

07 R6 Swap