FZRSupport: the FZROnline Archive

I had bought these blinkers last week for $25 off ebay supposed to be stealth with 3 leds in them .. When i got them they were a little bigger then i thought they would be so scoping out the rear end tryin to figure out where to put them .. after tryin here and there i decided to make them look like Intergrated Talight /signals .. so i came up with Inigrated version of my own .. first the housing of the tailight has these 2 little whole , i drilled them a bit bigger ..mounted the blinkers inside the tailight cover on the bottom of the glass. fed the wires through the whole on each side .and this is what they look like now a short ghetto video but you get the point or picture .. first the blinkers

now the vid..


in the dark


well that was my friday night .. now im off to wendys for a spicy chicken sandwich ..

that was a good idea i like i like

Pretty cool custom setup. I am not sure where you are located, but some states require a minimum distance between the signals. In Virginia where I live, integrated signals are illegal because of this, but thats not stopping me . I guess it helps that I am a state inspector at a dealership too....

cool setup. very creative.

not bad!

cell wrote:Pretty cool custom setup. I am not sure where you are located, but some states require a minimum distance between the signals. In Virginia where I live, integrated signals are illegal because of this, but thats not stopping me . I guess it helps that I am a state inspector at a dealership too....

thanks , didnt know where else to put them , they were advertised as stealth so this is as good as it gets .
Im in michigan and i dont really know if there is a law ..but i guess if u dont have signals you just use your hand to signal so this has to be better then nothing

Thats a cool way to do it and a lot cheaper than those ones on ebay sell for. I wanted to get the integrated ones for the r6 and they are selling for around $79.00. To much in my opinion.

95FZR600 wrote:Thats a cool way to do it and a lot cheaper than those ones on ebay sell for. I wanted to get the integrated ones for the r6 and they are selling for around $79.00. To much in my opinion.

the one they sell integrated for fzr i think over 120$ efing krazy i tell you , i just hope the 3m double sided tape works .. should be ok tho

PIMPMYFZR wrote:

95FZR600 wrote:Thats a cool way to do it and a lot cheaper than those ones on ebay sell for. I wanted to get the integrated ones for the r6 and they are selling for around $79.00. To much in my opinion.

the one they sell integrated for fzr i think over 120$ efing krazy i tell you , i just hope the 3m double sided tape works .. should be ok tho

That should work or get you that velcro tape.

I bought one of those clear alternatives taillights for myself with the integrated turns built it.. I forget how much they were but it was a long time ago.

Cool. The best indicatores I have seen ever. I did not know that "integrated indicators " existed. Clean and tidy. Good work