FZRSupport: the FZROnline Archive

Quick question.

I got some hi compression pistons in my FZR 400 engine. They are from Wiseco.

I put them in but they are hitting the top head so I need about 1.5mm between the two surfaces.
Q: what is the thickness of a stock gasket?

All I could find here is a very, very thin metal one (about 0.25mm thick) that hardly worked much less gives me the clearance I need.

not sure on the stock thickness, but Cometic will made special order gaskets and the wait time isnt that bad!

stack 2 base gaskets??

much cheaper than head gaskets.

no special order