FZRSupport: the FZROnline Archive

For those of you into exhaust pipe making / altering :-:-
http://icengineworks.com/icewtackingclamps.htm

Thats pretty cool but I dont own a welder. LOL

You could come up with all sorts of goodies with those clamps.

Very good find george!

95FZR600 wrote:Thats pretty cool but I dont own a welder. LOL

You could come up with all sorts of goodies with those clamps.

Very good find george!

Hi,

well they are certainly better than my hose clamps & thin strips that I used for aligning my two stroke pipes.

that is awesome as hell.
someone should get it and make some undertails for the FZR

shredex wrote:that is awesome as hell.
someone should get it and make some undertails for the FZR

Have you tapped into my pc? Im looking for a slip on to mount under my tail right now. I have a friend who said he will run the pipe and fit it using stainless. I cant wait. Thats my winter project to run the undertail exhaust using the existing 99-02 r6 tail.

cool but just putting some c clamps work for me, I mean it comes out perfect anyways

v8killaz wrote:cool but just putting some c clamps work for me, I mean it comes out perfect anyways

V8,
C clamps would have to be VERY carefully tightened not to distort the pipe, if using two I found they were a hinderence only allowing tack welds at not always the best position (unless you faffed about a lot with the clamps& pipe weight was a factor as to where you could put them.)


Hose clamps with in my case 3 lolly sticks were ideal 3d support not much chance of distorting the pipe,

Nice find George. I'm fowarding this to my buddy.

megaloxana wrote:Nice find George. I'm fowarding this to my buddy.

There might be a group buy on another list if so I will pass it on like I did the Vapour guages.

yamaha_george wrote:

megaloxana wrote:Nice find George. I'm fowarding this to my buddy.

There might be a group buy on another list if so I will pass it on like I did the Vapour guages.

yes please do.