FZRSupport: the FZROnline Archive

i have 90 fzr1000 with full vance and hines exhaust, i want to put exup back on it and dont have anything, need stock header pipe, exup servo and cables and stock muffler or slip on for stock header. thanks

I'm not sure where you are but from your request for a muffler I guess you're in the US

I have a spare servo but it's for the later RU model which has a different plug that fits the CDI. You can swap the plugs if you find a broken servo
Wemoto (Google search) supply cables cheaper than gen OEM

I also sell complete refurbished headers when I have them but shipping from the UK probably wouldn't make them viable
Here's the last set I did and sold
https://www.ebay.co.uk/itm/152106835545

yeah iam in the states, that is a very nice looking header. I imagine shipping would be crazy. I always thought the servos where the same but different plug good to know , at very least fab my own plug setup.

The 89-90 servo on the FZR1000 used the 6-way round Yazaki YPC female connector, while the 91-94 used the rounded-rectangular Sumitomo connector. The Cali 600s and 400s also used the round connectors. Later bikes like the YZF750 & 1000 used the Sumitomo or a 4-way unsealed connector and a bullet connector. The servos themselves are all the same, it's just the plug and length of cable that changes.

The round connector is older and harder to find; Eastern Beaver in Japan has them, but has a $20 minimum order. Cycle Terminal in the US carries the 3, 4, and -male- 6-way, but not the female. I have a few on my bench that I use for my EXUP Eliminators; if you can't find a servo with the right connector and aren't ready to buy an extra few connectors from Japan, I'll sell you one for cost and postage.