FZRSupport: the FZROnline Archive

1990 FZR400 track bike part-out

Hi guys,

I've decided to part out the bike. Please reference the pics of the complete bike found at the following location:

https://goo.gl/photos/EaMNyaACi9Y4yX3u8

Edited... I've updated the price on most of this stuff to reflect the inclusion of shipping cost.

*** PRICES INCLUDE SHIPPING TO 48 CONTIGUOUS STATES (except where noted) ***
*** Alaska, Hawaii, and International (if possible) will require a quote ***

front wheel #1 (3"x17") --- $75 + SHIPPING
* BT014 (plenty of tread), All Balls bearings (NEW!)

rear wheel #1 (4"x18") --- $90 + SHIPPING
* BT014 (plenty of tread), All Balls bearings (NEW!)

front wheel #2 (3"x17") --- $60 + SHIPPING
* includes tire with good tread (need to check brand)

rear wheel #2 (4"x18") --- $75 + SHIPPING
* includes tire with good tread (need to check brand)

rear rotor --- $25 SHIPPED

undertail --- $35 SHIPPED
* very end was chopped (see pics)

battery box --- $20 SHIPPED
* no strap

seat --- $35 SHIPPED
* small tear on rear left

Woodcraft clip-ons (38mm) --- $140 SHIPPED

clutch lever/boss --- $20 SHIPPED

clutch cable --- $15 SHIPPED

coils --- $45 SHIPPED
* includes wires, caps

starter solenoid --- $20 SHIPPED

ignition switch w/ key --- $30 SHIPPED

right switch pod --- $30 SHIPPED

Sharkskinz bodywork --- $200 + SHIPPING
* this bodywork is about $900 new
* includes upper, lower, tail, tank cover, and front fender
* various states of rashed (see pics)
* upper is actually in two pieces (held together by duct tape)
* lower only has a small gash that would need to be patched
* I'll throw in the fiberglass repair stuff I bought as well (fabric, resin, etc.)

TTT - lowered some prices...