Page 1 of 1
94 FZR 1000 Will not start
Posted: Thu May 31, 2012 4:36 pm
by tobynewton
I just bought this bike and have never owned a Yamaha I have always had Kawasakis but heard lots of good things about this bike. When I try to start it using the start switch the gas light comes on and it does not turn over, however, if I bypass the switch and stick a screwdriver on the stater solenoid then it turns over. And when the kill switch is in the off position it buzzes. Need some advice on what to do.
PS The person that had it before me messed with the wiring.
Re: 94 FZR 1000 Will not start
Posted: Fri Jun 01, 2012 1:17 pm
by Stig
sounds like the starter relay at fault or wiring connecting it
Re: 94 FZR 1000 Will not start
Posted: Fri Jun 01, 2012 9:43 pm
by DonTZ125
tobynewton wrote:And when the kill switch is in the off position it buzzes.
That's not good... Get out the wiring diagram (see the Wiki) and start tracing wires.
Re: 94 FZR 1000 Will not start
Posted: Tue Jun 26, 2012 2:49 pm
by tobynewton
Ok so I have bought A new wire harness and installed and now I have a plug towards the end of the harness that i do not know where it plugs to. The wires are red and brown with a blue stripe I have looked and looked and can not find were this plug goes.
it is the small black plug that is in question
Re: 94 FZR 1000 Will not start
Posted: Thu Jun 28, 2012 3:03 pm
by Stig
its a spare from memory
Re: 94 FZR 1000 Will not start
Posted: Sun Jul 22, 2012 1:19 am
by rcb
If you get your new harness in and it still does not start, make sure to check your neutral switch ground and/or clutch switch ground continuity. I recently had that experience, though on a different bike. Replaced several things before I checked the ground. Simultaneously had the clutch and neutral get bad ground at the exact same time. Just one of those really weird occurrences.
Re: 94 FZR 1000 Will not start
Posted: Sun Jul 22, 2012 1:59 am
by Stig
also these bikes have a side stand cut out that cuts poser if the bikes in gear and the stand is down. If thats fauty or a bad connection it wont start