FZRSupport: the FZROnline Archive

Hello.

So here's my problem.. I was idling my bike and side stand switch was hanging loose from the wires. Apparently hot exhaust pipe cut its wires so I don't have the switch anymore (later lost the switch itself too) So now the bike stalls when put on gear, maybe because of this? would it work if I grounded what's left of the wires or how does that side stand switch work?

Sorry for bad english

Yes, to bypass the sidestand switch just attach the single wire to ground.

I thought to bypass the sidestand you just take the two wires and connect them together creating the circuit.

I'm probably wrong though, I need to brush up on my electronics

Yeah, you were right. There are two wires. Just connect them. One is ground. I goofed.

Uh....what they said